AlliedSignal KAP 140 Manual de Instalação descarregar pdf (Página 24)

BENDIX/KING

KAP 140

Page 2--4

Revision 6, Oct 2002

CS:00991I06.IDU

2.3.3.1.3 Configuration Procedure

1. To configure/install the flight computer, the following must be completed:

AFCS system harness installation checked (ring test).

Aircraft ground power applied.

A vionics power applied.

Sensors operating (Turn Coordinator, DG/HSI, nav’s).

RS232 communications established with FCC.

The remote terminal should now display the following menu:

System Mode: Normal ( or Diagnostics)

KC 140 Flight Computer

-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --

D -- Diagnostics

L -- Error Log

S -- Display SW ID

N -- Installation

Press any key for desired option:

2. Press “N” to enter the installation menu. The terminal should display a menu with, “1.

Installation Setup”. Press “1”. Now the terminal should display the message: “Upload

installation file or press <ESC> to abort”. Use the terminal program of the PC to send the

correct certification file. When the file transfer is complete, the terminal should display the

message, “Installation data have been saved in nonvolatile memory”. Press <CR> to return

to the installation options page. Set the audio volume to the desired value and select the other

options, as appropriate. The options displayed will depend upon the aircraft certification and

the version of the FCC. The following describes all available options and their meaning.

NOTE

The Certification files for existing KAP140 certifications is distributed

on diskette from the f actory (See Section 1.4.3). Insert this diskette

into the PC and select the floppy drive to view the contained files.

Certifications files are named for the target aircraft and have a “.CER”

filename extension. Use the file transfer ability of the terminal

program to “send text file”, using the selected certification file.

A volume setting of “0” is the minimum level and “7” is the maximum.

A “1” for “Voice Msg Enabled” will enable voice messages for AP disconnect and altitude

alerting, in addition to the normal tones produced for these events. (This option is not available

on the --2501 (MOD1) --5XX1, --7XX1 versions of the KC140).

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 93 94

Sem comentários

AlliedSignal KAP 140 Manual de Instalação Página 24